PharmaSystems AutoDrop Eye Drop Guide

How to Use Instructions for use: 1. Open AutoDrop®. Loosen cap from eye drop bottle but do not remove completely. 2. Locate the keyhole slot around the base of the bottle neck below the thread. Remove bottle cap. 3. Close AutoDrop®. Do not force the bottle nose into AutoDrop®, it should close easily. 4. Hold down lower eyelid. Place AutoDrop® over the eye with the lip against the cheek. 5. Tilt the head backwards. Look through pin-hole towards the light. 6. Squeeze bottle gently to allow the prescribed number of drops to fall into the eye. 7. Open AutoDrop® and replace top on eye drops bottle between doses. 8. To clean AutoDrop® remove eye drop bottle and wash AutoDrop® in warm soapy water. Rinse and dry thoroughly. Warnings CAUTION: It is recommended for AutoDrop® to be used for the whole course of treatment for an eye disorder. When an eye drop bottle is discarded, remove AutoDrop® and clean thoroughly before fitting to the new bottle. AutoDrop® may be used on more than one type of eye drop at the same time, however if you suffer from more than one eye complaint we recommend that you use a separate AutoDrop® for each type of eye drop. For use in hospitals and clinics: AutoDrop® may be autoclaved on a low pressure cycle for 30 minutes. Release clip to allow moisture to evaporate. AutoDrop® can also be cleaned in sterilizing fluid. Rinse and dry thoroughly.